JVC POWERED WOOFER CD SYSTEM RV-B99 BK/BU Benutzerhandbuch
19
Presetting the desired stations (using the remote control unit)
30 stations in FM band and 15 stations in AM (MW/LW) band can be
preset as follows:
preset as follows:
÷
Example: (Presetting an FM station broadcasting on 103.5 MHz to preset
button “15”)
button “15”)
1
Press the TUNER BAND/FM MODE button.
2
Select the FM band using the TUNER BAND/FM MODE button.
3
Tune to the required station.
4
Press preset button “+10”, then “5” for more than 2 sec.
(When “15” blinks in the preset station display, the station has been
stored.)
(When “15” blinks in the preset station display, the station has been
stored.)
÷
Repeat the previous procedure for each of the other stations, using a
different preset button each time.
different preset button each time.
÷
Repeat the previous procedure for the other band.
÷
To change preset stations
Perform step
Perform step
4
after tuning to the required station.
Notes:
÷
The previously stored station is erased when a new station is stored,
because the new station’s frequency replaces the previous frequency
in memory.
because the new station’s frequency replaces the previous frequency
in memory.
÷
When listening to an AM (MW/LW) broadcast, noise may be heard if
the remote control unit is used.
the remote control unit is used.
SLEEP
PROGRAM
RANDOM
REPEAT
AUTO
PRESET
SOUND
DISPLAY
REVERSE MODE
MULTI CONTROL
FM MODE
REW
FF
TAPE
TUNER
BAND
C D
DOWN
UP
SET
AUX
ACS
4
1
2
3
3
MHz
To prevent the preset stations from being erased because of a power
failure, etc., install memory back-up batteries in the unit (see page
6).
failure, etc., install memory back-up batteries in the unit (see page
6).
Preset station tuning
(Receiving the preset stations)
(Receiving the preset stations)
÷
The stations must be preset before this operation can be performed.
(Using the main unit)
1
Press the TUNER BAND button.
2
Select the band using the TUNER BAND button.
3
Each time the PRESET TUNING button is pressed, the next preset
station is selected.
station is selected.
(Using the remote control unit)
1
Press the TUNER BAND/FM MODE button.
2
Select the band using the TUNER BAND/FM MODE button.
3
Press the required preset station buttons (No. 1 – No. 10 and +10).
÷
The preset station number and frequency corresponding to the button
pressed are shown.
pressed are shown.
FM:
Adjust the telescopic antenna’s length, angle and
direction until optimum reception is received.
direction until optimum reception is received.
AM (MW/LW): Install the unit where suitable reception is possible (beside
a window, etc.) or change the direction of the unit.
Note:
The built-in ferrite core antenna can pick up interference from television
receivers in the neighborhood and thereby disturb AM (MW/LW) reception.
The built-in ferrite core antenna can pick up interference from television
receivers in the neighborhood and thereby disturb AM (MW/LW) reception.
FM
AM (MW/LW)
Using the antennas