High End Systems High End LCD Controller for Studio Color Benutzerhandbuch

7-12

RAM Card: Write-Protection

Studio Color LCD Controller

After backing up either the operating system or memory to 
the RAM card, you should write-protect that card to prevent 
it from being inadvertently erased.

Examine the end of your RAM card to locate the small write-
protect tab.  Also note the battery release, typically located 
near the battery compartment.  Do not disengage the battery 
release, since that could cause the battery to fall out of the 
RAM card.

Figure 7-1 below shows the RAM card shipped with 
the Studio Color LCD controller (part number 
80440017).  Because of the wide variety of 
compatible RAM cards available, you should consult 
the documentation provided with your RAM card if 
you are unsure of the location of its components.

Figure 7-1 shows the locations of the write-protect tab and 
the battery release on the RAM card that is being shipped 
with the Studio Color LCD controller at the time of this 
writing:

Figure 7-1.  Slide the write-protect bar to the right to 
allow the RAM card to accept data, or move it to the 
left to prevent it from accepting data.

MEMORY CARD

Not protected

Write-protected
(locked)

Battery compartment

Battery release

Write protect

tab