Compex Technologies WP11A+ Benutzerhandbuch
Appendix III Configuration and Commands on Telnet Interface
89
5. Go to Recovery folder and activate wp11arcv.bat.
The system will go to DOS Prompt automatically. Press any key to restore the
firmware. It will run the command from the batch file: TFTP -i 192.168.168.1
PUT Wp11a286.img as shown below.
firmware. It will run the command from the batch file: TFTP -i 192.168.168.1
PUT Wp11a286.img as shown below.
Figure AIII-2
DOS Prompt Environment
When done, the system will prompt you a message “Transfer successful:
505807 bytes in 1 seconds, 505887 bytes/s”.
505807 bytes in 1 seconds, 505887 bytes/s”.
When the firmware image file is uploaded, it will copy it to the flashrom.
During uploading the firmware image file to Compex WP11A+, the DIAG LED
will light up.
During uploading the firmware image file to Compex WP11A+, the DIAG LED
will light up.
NOTE
The firmware image file, which you upload from the CD-ROM may not be the
latest version. To get the most updated version, please go to
www.compex.com.sg to download the firmware. Do not power down the device
as data is being transferred.
The firmware image file, which you upload from the CD-ROM may not be the
latest version. To get the most updated version, please go to
www.compex.com.sg to download the firmware. Do not power down the device
as data is being transferred.
Please note that your firmware image file might be different. Please enter the
name of that image file.
name of that image file.
Please ensure that there is constant power supply to Compex WP11A+ while
performing the recovery process.
performing the recovery process.