Fluke Lawn Mower 2635A Benutzerhandbuch
2635A
Users Manual
2-16
Configuring a Channel Off
Perform the procedure in Figure 2-10 to configure a channel for off (no measurement).
In preparation, the instrument must be in the inactive mode (not scanning or monitoring)
and the desired channel must be selected (see Figure 2-3). To exit at any time (changes
not saved), press the
In preparation, the instrument must be in the inactive mode (not scanning or monitoring)
and the desired channel must be selected (see Figure 2-3). To exit at any time (changes
not saved), press the
C key. When a channel is OFF, it cannot be scanned or
monitored. When a channel function is changed, alarm limits and scaling (Mx+B) for
that channel are changed to their default conditions.
that channel are changed to their default conditions.
FUNC
ENTER
SET FUNC
OFF
°
F [
°
C]*
Hz
Ω
VAC
V DC
V DC
Typical
Required
Selecting the OFF Mode. Press the FUNC key
to access the SET FUNC (Set Function) menu.
Press the up/down arrow keys until OFF is
displayed, then press the ENTER key.
to access the SET FUNC (Set Function) menu.
Press the up/down arrow keys until OFF is
displayed, then press the ENTER key.
* Depends on
temperature scale.
temperature scale.
op22f.eps
Figure 2-10. Configuring a Channel Off
Setting Operating Conditions
After the channels are configured for the desired measurement parameter, set the
following operating conditions to support the intended instrument function:
following operating conditions to support the intended instrument function:
•
Setting the Scan Interval [Default - 0:00:00 (Continuous)] (Figure 2-11)
•
Setting the Measurement Rate [Default - Slow] (Figure 2-12)
•
Setting the Alarms [Default - Alarms off] (Figures 2-13)
•
Setting the Mx+B Scaling [Default - 1x+0 (no scaling)] (Figure 2-14)
The instrument default settings for each of the above are shown.