World Marketing of America KOZY-WORLD KWN109 Benutzerhandbuch

Seite von 14
3
PRODUCT   FEATURES
SAFETY  DEVICE
A   standard  requirement  for all vent-free   room
heaters, this  heater has a pilot  with  an  Oxygen
Depletion  Sensor(ODS)  safety  shutoff  system.
The ODS/pilot  shuts  off  the heater  if  there  is
not  enough  fresh  air.
PIEZO  IGNITION  SYSTEM
This   heater  is   equipped  with   a   piezo   ignitor.
This  system  requires   no   matches, batteries, or
other  sources  to  light  heater.
THERMOSTATIC  HEAT
CONTROL  ON  THERMOSTAT
MODELS
These    heaters    have    a    control    valve    with    a
thermostat    sensing    bulb.  This    results    in    the
greatest    heater    comfort    and    may    result    in
lower  gas  bills.
LOCAL  CODES
Install  and  use  heater  with  care. Follow  all  local
codes. In  the  absence  of  local  codes, use   the
latest  edition  of  National  Fuel  Gas  Code  ANSZ223.1,
also  known  as  NFPA  54*.
*Available  from :
         American  National  Standards Institute, Inc.
1430  Broadway
         New York, NY 10018
National  Fire  Protection  Association, Inc.
 Batterymarch  Park
Quincy, MA  02269
UNPACKING
1.   Remove  heater  from  carton.
2.   Remove  all  protective   packaging  applied  to
      heater  for  shipment.
3.    Check  heater  for  any  shipping  damage. If  heater
      is  damaged,  promptly  inform  dealer  where  you
       bought  heater.
Figure1-Vent-Free   Natural   Gas  Heater
W ater  vaporis  a  by-product  of  gas  combustion.An
unvented room heater productes approximately one (1)
ounce (30ml) of wter for every 1,000 BTU’s (.3KW’s) of
gas input per hour.
U n ven ted   ro o m   h eaters  are  rem om m en d ed   as
supplemental heat (a room) rather than a primary heat
source  (an entire  house) .In  most supplemental heat
application, the water vapor does not create a problem.
In most applications, the water vapor enhances the low
humidity atmosphere experience during cold weather.
WATER VAPOR: A BY-PRODUCT OF UNVENTED ROOM HEATERS
The following steps will help insure that water vapor
does not become a problem.
1.  Be  sure  the  heater  is  sized  properly  for  the
application,  including  ample  combusion  air  and
circulation air.
2. If  high humidity is experienced, a dehumidifier may
be used to help lower the water vapor content of the
air.
3. Do not use an unvented room heater as the primary
heat source.