Sears Paint Sprayer 486.245313 Benutzerhandbuch

6

•  Assemble the large and small spray gun clips to the 

side of the tank using two #10 x 1/2" screws and #10 
lock washers. See figure 7.

•  Slide a 3/8" hose clamp onto the boom connecting 

hose. Place the end of the hose through the conduit 
clamp (attached to the pump) and then slide a second 
3/8" hose clamp onto the hose. Leave hose clamps 
loose for now. See Figure 8.

•  Push the hose onto the hose adapter in the end of 

the "On-Off" valve. Tighten the hose clamp around the 
hose and adapter. See figure 8.

•  Position the valve and hose clamp up against the 

conduit clamp. Slide the other hose clamp against the 
other side of the conduit clamp. Tighten the clamp 
without collapsing the hose. See figure 8.

•  Slide the coiled hose clamp onto the spray gun hose 

and then push the hose onto the hose adapter on the 
1/4" tee fitting. Tighten the hose clamp around the 
hose and adapter. See figure 8.

•  Snap the spray gun into the clips on the front of the 

tank. (The large clip holds the spray gun handle and 
the small clip holds the wand.) Refer to figure 7.

 

DANGER!  Never allow negative pin on 
plug to come in contact with positive 
"hot" post on battery.  Fire or explosion 
may result!

IMPORTANT: This sprayer should be connected to 12 
volt batteries only!

•  To connect the wire harness to the tractor, attach the 

red wire to the positive post on the battery or to the 
"HOT" connection on a tractor switch or ammeter.  
The  brown wire may be grounded or connected to the 
negative battery post.  See figures 9 and 10.