Tyco Electronics 0-1591093-X Benutzerhandbuch
24 and 16 Port Smart Switch II – User Manual
Page 4
Front Panel
The front panel of the switch has 24 or 16 x RJ-45 Ethernet Ports, an
optional fibre uplink port, a console management port and an array
of LED indicators.
optional fibre uplink port, a console management port and an array
of LED indicators.
Figure 1 – Switch with optional fibre module (SC Connector) fitted
Ports
!
!
!
RJ-45 Ports. These Ethernet RJ-45 ports support both
shielded and unshielded cabling systems. The port
auto-negotiates the 10/100Mbit/s network speed or can be
forced by the console management interface into either
10Mbit/s or 100Mbit/s at either full-duplex or half-duplex.
Each port supports Auto-MDI/MDI-X, which allows either
straight through or crossover cables to be used.
shielded and unshielded cabling systems. The port
auto-negotiates the 10/100Mbit/s network speed or can be
forced by the console management interface into either
10Mbit/s or 100Mbit/s at either full-duplex or half-duplex.
Each port supports Auto-MDI/MDI-X, which allows either
straight through or crossover cables to be used.
Fibre Port Uplink. This optional, field installable plug-in
module provides the fibre link to the distant media converter,
NIC card or Ethernet switch. Modules are available that
provide support for 100Mb/s Fx (multimode or single mode)
and also dual Gigabit Sx and Lx. See page 8 for order
codes.
NIC card or Ethernet switch. Modules are available that
provide support for 100Mb/s Fx (multimode or single mode)
and also dual Gigabit Sx and Lx. See page 8 for order
codes.
Console Port. A PC or other RS232 terminal can be
connected to this port to enable detailed management of the
switch. See Page 11 on for details.
switch. See Page 11 on for details.
Rear Panel
The rear panel contains the 100/240v AC 50/60Hz power socket
and power switch. Note that the fusing is external to the switch. To
disconnect power from the switch remove the plug from rear.
and power switch. Note that the fusing is external to the switch. To
disconnect power from the switch remove the plug from rear.
Product Number 0-1591093-x 0-1591047-x Issue 1
© Tyco Electronics 2005