Panasonic Arbitrator 360 Betriebsanweisung

Seite von 8
11
4
INSTALLATION & OPERATION
Installation:
1) Install the mounting bracket by using the screws
2) Slide the RX Set onto the bracket
3) Connect the main cable to the RX
4) Connect external antenna to the RX
Operation:
1) Charge the TX for at least 3 hours 
2) Switch the power on (located on the bottom of the TX)
3) Place the TX into the RX to synchronize
Note:  Disconnect the battery or turn off the device when the TX is not in use 
for long periods of time
CAUTION 
Warning
Do not continue charging the battery if it does not charge within the specified 
charging time. Doing so may cause the battery to become hot, 
explode, or ignite. There is a risk of explosion if the battery is replaced 
by an incorrect type.
Dispose of used batteries according to the instructions.
2. While Charging
Caution
The temperature range over which the battery can be charged is  
10
°C to 45°C. Charging the battery at temperatures outside of this 
range may cause the battery to become hot or to break. Charging the 
battery outside of this temperature range may also harm the 
performance of the battery or reduce the battery’s life expectancy.
3. When Discharging the Battery
Danger
Do not discharge the battery using any device except for the specified device. 
When the battery is used in devices aside from the specified device it 
may damage the performance of the battery or reduce its life 
expectancy, and if the device causes an abnormal current to flow, it 
may cause the battery to become hot, explode, or ignite and cause 
serious injury.
Caution
The temperature range over which the battery can be discharged is                
-10
°C to 45°C. Use of the battery outside of this temperature range 
may damage the performance of the battery or may reduce its life 
expectancy.
Antenna Location:
1) Place external antenna on the windshield at the point        
(Horizontal or Vertical) as shown in the following picture:
Installation must only be conducted by a qualified technician