PASCO Specialty & Mfg. PHOTOGATE MOUNTING BRACKET ME-6821A Merkblatt
®
I n s t r u c t i o n S h e e t
0 1 2 -0 5 0 1 3 D
Photogate Mounting Bracket
ME-6821A
Introduction
The PASCO Model ME-6821 Photogate Mounting Bracket is
designed for use as an accessory to the PASCO Projectile
Launcher. It attaches to the front of the launcher and holds
one or two photogates in parallel.
designed for use as an accessory to the PASCO Projectile
Launcher. It attaches to the front of the launcher and holds
one or two photogates in parallel.
Experiments
Please refer to the experiment guide that comes with the appli-
cable PASCO equipment for specific experiments.
cable PASCO equipment for specific experiments.
Setup procedure
1.
Loosen the thumbscrew of the Photogate Mounting
Bracket.
Bracket.
2.
Align the bracket assembly with the front of the Projectile
Launcher and slide the alignment key down the groove of
the barrel.
Launcher and slide the alignment key down the groove of
the barrel.
NOTE: The flat side of the square nut must face the inside of the projectile
launcher groove as shown.
launcher groove as shown.
3.
Slide the Photogate Mounting Bracket to the desired posi-
tion and tighten the thumbscrew to secure.
tion and tighten the thumbscrew to secure.
4.
Unscrew the small rod clamp from the Photogate Head.
(Save the clamp and its 6-32 x 5/8" thumbscrew for later
use.)
(Save the clamp and its 6-32 x 5/8" thumbscrew for later
use.)
5.
Attach each Photogate Head to the Mounting Bracket
with one of the 6-32 x 3/4" thumbscrews included with
the bracket assembly.)
with one of the 6-32 x 3/4" thumbscrews included with
the bracket assembly.)
Additional Equipment Required:
Part Number
Projectile Launcher
ME-6800,
ME-6801 or
ME-6823
ME-6801 or
ME-6823
(2) Photogate Heads
ME-9498A
Additional Equipment
Recommended:
Recommended:
Part Number
Shoot-the-Target Accessory
ME-6805
Time-of-Flight Accessory
ME-6810