Polaris D7500 Benutzerhandbuch
3
GENERAL SAFETY
This equipment has been designed to minimize exposure of personnel to hazards .
While the Polaris System is designed for safe operation, certain precautions must
be observed . Use of the Polaris System not in conformance with the instructions
specified in this manual may result in permanent failure of the unit .
KNOWLEDGE OF WARNINGS AND CAUTIONS
KNOWLEDGE OF WARNINGS AND CAUTIONS
Users must exercise every precaution to ensure personnel safety, and be
familiar with the warnings and cautions presented throughout this manual
and summarized below .
Warnings.
Warnings.
To prevent fire or electrical shock, do not expose this equipment to rain or
moisture .
Do not spray cleaning liquids or disinfectants directly on the camera
handpiece or the Handpiece Cable . Use care not to allow liquids to run
into internal circuitry .
Do not wipe the surfaces using benzine, thinner, etc . as this may degrade
the finish .
Cautions.
There are no user-serviceable parts inside . Servicing should be per-
formed by qualified dealer service representatives only .
Connecting any device to the Polaris System that does not meet the equivalent
safety requirements of the system may reduce the safety effectiveness of the
Polaris System .
Unplug the system components from power before performing cleaning
procedures .
Contraindications.
None known .
Do Not Attempt Internal Service.
The interior of the camera is only accessible by removing hardware with tools
and should only be opened and serviced by an authorized service technician .
Contact your local Air Techniques authorized dealer for service . Failure to heed
Contact your local Air Techniques authorized dealer for service . Failure to heed
this directive may result in equipment damage and voiding the warranty .
Use of Accessory Equipment.
All peripheral equipment (computers, monitors, printers, etc) connected to this
equipment must comply with IEC 60601-1 and the resulting system must comply
with IEC 60601-1 and/or IEC 60601-1-1 harmonized national standards when
set-up within the immediate patient vicinity (ie . within 6 feet) .
Accessory equipment outside the patient vicinity must comply with IEC 60601-1
or IEC 60950-1 as allowed by IEC 60601-1-1 .
Use of ACCESSORIES or cables other than those specified or provided by Air
Techniques may result in increased EMISSIONS or decreased IMMUNITY of the
equipment .
All peripheral equipment (computers, monitors, printers, etc) connected to this
equipment must comply with IEC 60601-1 and the resulting system must comply
with IEC 60601-1 and/or IEC 60601-1-1 harmonized national standards when
set-up within the immediate patient vicinity (ie . within 6 feet) .
Accessory equipment outside the patient vicinity must comply with IEC 60601-1
or IEC 60950-1 as allowed by IEC 60601-1-1 .
Use of ACCESSORIES or cables other than those specified or provided by Air
Techniques may result in increased EMISSIONS or decreased IMMUNITY of the
equipment .