TERK Technologies 138P005 Merkblatt

Seite von 1
Limited Warranty 
TERK Technologies Corp. (TERK) warrants this product against defects in materials or 
workmanship for one (1) year from the date of purchase. During this warranty period, this 
product will be replaced without charge. This warranty does not cover any damage due to 
acts of nature, commercial use, accident, misuse, abuse or negligence. This warranty is 
only valid in the USA. Replacement as provided under this warranty is the exclusive remedy 
of the consumer. TERK shall not be liable for any incidental or consequential damages for 
breach of any express or implied warranty on this product, except to the extent that 
limitations of this sort are prohibited by applicable law. THERE ARE NO IMPLIED 
WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURCHASE 
EXCEPT TO THE EXTENT THAT IMPLIED WARRANTIES OF EITHER SORT ARE REQUIRED  
BY APPLICABLE LAW, AND IN SUCH CASE, EACH WARRANTY IS LIMITED IN DURATION  
TO ONE YEAR.
Installation Instructions::
Make sure the installation location is  
clean and dry. 
To install the antenna tail, place it against the antenna and 
route cable into the cable channel. Take the tail adhesive 
and remove the backing from one side. Place firmly onto 
the back of the tail over the routed cable. Then, remove 
the backing from the other side of the adhesive.   
Place the SIR-Mini with tail on your roof or trunk in the 
predetermined antenna location 
(as shown in Fig.1)
and press down firmly to secure antenna tail.
Route the antenna cable to the SIRIUS receiver. 
Avoid blocked passages and any obstructions that 
could kink, crimp, twist, or chafe the cable. If the 
antenna is located on your vehicle roof then it is 
necessary to push the cable under the rear window 
molding. 
(as shown in Fig.2)
Connect the SIR-Mini into the antenna input on the back 
of your SIRIUS receiver.
Please refer to your SIRIUS receiver owner’s manual 
to activate SIRIUS service and complete your SIRIUS 
system installation. 
2
3
1
4
4
6
5
Pre Installation::
The antenna has a magnetic base and must be installed on 
a conductive metal surface on the outside of the vehicle.
Position the antenna in such a way that it will be free of 
mechanical (i.e. an outward-opening moon roof) and 
line-of-sight obstructions such as roof racks, luggage boxes, 
etc. In these instances, consider positioning the antenna 
offset from the vehicle centerline.
Recommended installation locations are the roof of the 
vehicle above the rear window or on the top of the trunk 
near the rear window. (as shown in Fig.1)
MINI ROOF MOUNT ANTENNA 
Satellite Radio
Magnet Mount Antenna with 
21 F
oot C
able 
SIR-MINI
Fig.2
Fig.1
Push cable under molding
Predetermined antenna locations
Specs:: 
Frequency: 
2320 to 2332.5 MHz 
Cable Length: 
21 feet 
Terrestrial Gain: 
-4 dBiVp, 1˚elevation
Satellite Gain: 
+2 dBic, 20˚elevation 
 
3 dBic, 25 - 45˚elevation
 
4.5 dBic, 50 – 85˚elevation
 
4.0 dBic, 90˚elevation
Gain: 34.5 
dB 
Typical
Operating Temperature: 
-40˚ F to 185˚ F 
SIRIUS approved: 
RX0042-0202
For more information, visit www.terk.com, 
For technical support, call 1.800.942.TERK (8375)  
For more information about SIRIUS Satellite Radio service, 
visit, www.siriusradio.com 
Made in China
One year limited warranty 
The SIRIUS name and related logos are trademarks of 
SIRIUS Satellite Radio Inc. 
TERK and TERK Technologies are trademarks of 
TERK Technologies Corp. Commack, NY
©2004 TERK Technologies Corp.
If the SIR-Mini is being used with an older dual input SIRIUS receiver the SIR-SP,
SIRIUS splitter will be required. 
Installation instructions printed on the inside of this card::
138P005