Nextel comm BRR-L Benutzerhandbuch

Nextel RoadRunners Scanner Programming Guide 

Last updated: 10/14/05 

 

1

© Baracoda 2005 

This manual contains the necessary barcodes to configure the parameters of your scanner. You can either print 
out this document to scan its barcodes or in some cases you can even scan the barcodes right off your computer 
screen. 

The RoadRunners scanner can be programmed by 
scanning barcode labels which contain commands for the 
1D decoder.  

The programming labels must be Code128, with specific 
starting and ending characters. These labels will always be 
read, even if Code128 symbology is disabled.  

Programmable options are divided into two groups: 

1 

Controls for the general behavior of the scanner;  

2 

Decoding parameters for each barcode symbology. 

The scanner will acknowledge the correct and valid 
reading of a programming bar code label by emitting two 
beeps and both the RSL and BCL LEDs (see Figure 1) will 
light up green. The scanner will emit two other beeps 
(lower tone) and the red RSL LED will light up to indicate 
either an invalid or incorrect reading of the programming 
barcode. 

 

CAUTION: PLEASE DO NOT READ THE PROGRAMMING BARCODES WHILE PAIRED WITH A HANDSET 
OR CONNECTED TO THE BARACODAMANAGER. 

Fig. 1