Keating Of Chicago Top-Side 1-800 Benutzerhandbuch

(Continued)

Motor runs but will not

pump oil.

Motor not making any

noise

Oil not pumping through

the hose

Oil has not penetrated the filter

paper

Not plugged in

Motor has overheated

Valve not switched to “Oil to Hose”

1. Let oil sit in the filter pan for 

approximately 2 minutes and try again

1. Plug filter into the receptacle inside of 

cabinet

2. Turn ON/OFF switch to ‘ON’.

1. Allow motor to cool for approximately 10 

minutes.

2. Press the reset button near the ON/OFF 

switch on the filter control panel and try 

again.

1. Set the black knob in the middle of the 

filter control panel to the far left.

PREVENTIVE MAINTENANCE: Familiarize yourself with the proper filtering procedure prior to

attempting to filter

1. To remove water, stir oil until bubbling stops; water will clog filter paper pores.
2. Verify all connections, especially quick disconnects (under tub and inside fryer or CF cabinet) are

tight; not leaking oil or sucking air.

3. Use only one sheet of filter paper properly sealed under hold down ring.
4. Use a drain clean out rod if partial or full blockage in fryer drain is suspected.
5. If filter was used for fryer boil out, run oil through filter to lubricate motor/pump.
6. Clean filter and all components after each use. Do not permit oil to remain in filter drawer; it will clog

the pump.

7. Verify all lights and controls operate.
8. Adhere to operating instructions in sequence given for proper filtration.
9. Prepare filter for next use by using new filter paper and Acidox Powder for each fryer.

– 7 –