Compustar 2WFMRS Benutzerhandbuch

Seite von 9
© 2001 Firstech, Inc.  Page 7  
 
 
 
Safety Shut Down Features
  
 
CompuStar system has several shut down safety features. The following actions will shut down the engine or prevent the vehicle from auto-starting:  
Opening of the car engine hood, Pressing of the brake or Valet mode is turned on. 
 
 
OPTIONAL PROGRAMMABLE FEATURES 
These additional programmable features can be programmed to the CompuStar system by your authorized CompuStar dealer.    
 
Ignition Lock  
 
Automatic Transmission Vehicle: This programmable option enables your vehicle to automatically lock the doors upon starting the vehicle with a key.  
In addition, the vehicle will automatically unlock the doors upon pulling the key out from the ignition.  This option must be chosen at the time of 
installation. 
  
Manual Transmission Vehicle or Turbo Mode: This programmable option will locks the doors in 5 seconds after starting the vehicle with a key and 
the emergency brake is released.   
 
 
Passive Locking  
 
You can turn this function on or off by pressing Buttons (II+III) for a ½ second.   
1.  When set to passive locking, your doors will lock automatically 30 seconds after all the vehicle doors are closed.   
 
 
Turbo Mode  
 
If this optional Turbo Mode has been programmed at the time of installation, you can turn this feature on and off by pressing Buttons (III+IV) for 
a ½ second.  
 
Under this mode, the engine continues running for 2 minutes after key has been taken out from the ignition if emergency brake was on when the key 
is taken out.  To utilize this mode, the emergency brake sensing wire has to be connected to the emergency brake wire of the vehicle. Consult the 
authorized dealer for this mode. 
 
OPTIONAL INSTALLATION FEATURES  
 
The CompuStar 2WFMR(S) remote has additional features and expansion possibilities that require additional parts and labor.  
 
 
Cold Start Mode  
 
If the optional temperature sensor has been installed, Timer Start Mode becomes Cold Start Mode. Under this mode, your vehicle will 
automatically start if the temperature of the inside of the vehicle goes below the preset temperature. The minimum interval between the starts will be 
1.5 or 3.0 hours depending on preset options during the time of installation. Cold Start Mode is activated or deactivated by pressing Buttons (II+IV) 
for a ½ second.