Compatible Systems 10/100 Benutzerhandbuch
Chapter 4 - LED Patterns
10
Chapter 4 - LED Patterns
Some of the LEDs on the front of the IntraPort Carrier VPN Access Server serve dual func-
tions. In addition to indicating certain server-wide operating conditions, they may also display
port-specific information.
v Note: Any continuous flashing pattern not noted in this chapter may be caused by a hard-
ware failure. Please call Compatible Systems Technical Support if your server shows a hard-
ware failure.
tions. In addition to indicating certain server-wide operating conditions, they may also display
port-specific information.
v Note: Any continuous flashing pattern not noted in this chapter may be caused by a hard-
ware failure. Please call Compatible Systems Technical Support if your server shows a hard-
ware failure.
Server LED Patterns
Over Temp
The server is above the proper operating temperature. The filter needs changing. See the
appendices in the IPC Chassis manual for instructions.
appendices in the IPC Chassis manual for instructions.
Sys Ready
The server booted properly without detecting any failures.
General Indicators
Ethernet Traffic Indicators
TX: Ethernet transmit packet
RX: Ethernet receive packet
Load % Indicators
These lights indicate the load on the DES card.
Ethernet Lights
Load Lights
Indication
5 flashing
20 flashing
Server stacks starting up.
3&4 flashing
40&60 flashing
No OS loaded. Running from ROM.
1&4
flashing
40&100
flashing
Erasing OS in Flash ROM.
5
flashing
20,40&60
flashing
Erasing config in Flash ROM.
Scanning from the outside toward the center
Flash ROM erase due to switch setting five or six is
complete. Set switch to zero and cycle power.