Azden SGM3416 Benutzerhandbuch
2
Thank you for purchasing the Azden SGM-3416/3416L broadcast-spec shotgun microphone. Designed for
video and audio professionals, the SGM-3416/3416L is a super-directional electret condenser microphone
with a wide frequency response and ultra-low noise levels. Each SGM-3416/3416L is tested before leav-
ing the factory and accompanied by its own frequency response chart.
video and audio professionals, the SGM-3416/3416L is a super-directional electret condenser microphone
with a wide frequency response and ultra-low noise levels. Each SGM-3416/3416L is tested before leav-
ing the factory and accompanied by its own frequency response chart.
POWER
The SGM-3416/3416L is powered by external Phantom Power. To power the unit, connect an XLR cable
(not included) to the microphone with a voltage source that supplies between 11 and 52 VDC.
(not included) to the microphone with a voltage source that supplies between 11 and 52 VDC.
MIC OUTPUT
The SGM-3416/3416L has a balanced 3-pin XLR output and will work in any impedance microphone input
of 1K ohm or less. Due to the wide variety of possible connections and equipment used with the SGM-
3416/3416L, an output cable is not supplied.
of 1K ohm or less. Due to the wide variety of possible connections and equipment used with the SGM-
3416/3416L, an output cable is not supplied.
WIRELESS OPTION
The SGM-3416/3416L can be turned into a wireless microphone by purchasing one of Azden’s unique XLR
plug-in transmitters and matching receiver. For more details, contact your Azden dealer or visit our web-
site at www.azdencorp.com
plug-in transmitters and matching receiver. For more details, contact your Azden dealer or visit our web-
site at www.azdencorp.com
SHOCK-MOUNT HOLDER
The SGM-3416/3416L is supplied with a shock-mount holder and a replacement bottom plate for boom
pole/tripod. Push the barrel into the clips until it is secured. To secure the holder to a camera shoe, slide
the older into the camera shoe and tighten the thumb wheel by turning it clockwise until it is tight. To
mount the SGM-3416/3416L onto a boom pole or tripod, replace the bottom plate of the shock-mount
holder with the supplied bottom plate with a 3/8” threaded hole and screw the holder to a boom pole/
tripod by turning it clockwise.
pole/tripod. Push the barrel into the clips until it is secured. To secure the holder to a camera shoe, slide
the older into the camera shoe and tighten the thumb wheel by turning it clockwise until it is tight. To
mount the SGM-3416/3416L onto a boom pole or tripod, replace the bottom plate of the shock-mount
holder with the supplied bottom plate with a 3/8” threaded hole and screw the holder to a boom pole/
tripod by turning it clockwise.
Balanced 3-pin XLR output
Shield
Cold
Hot