ANUBIS R00 Benutzerhandbuch
39
Connect the adapter to a proper power source. The voltage requirements are
found on the product case and/or packaging.
found on the product case and/or packaging.
Do not use the adapter if the cord becomes damaged.
Do not attempt to service the unit. There are no serviceable parts inside.
Replace the unit if it is damaged or exposed to excess moisture.
Replace the unit if it is damaged or exposed to excess moisture.
Never force a connector into a port. If the connector and port don
’t join with
reasonable ease, they probably don
’t match. Make sure that the connector
matches the port and that you have positioned the connector correctly in
relation to the port.
relation to the port.
When removing the connector from the port remove it by pulling on the
connector, not the cable. Make sure at least one end of the power cord is within
easy reach so that you can unplug the device when you need to.
connector, not the cable. Make sure at least one end of the power cord is within
easy reach so that you can unplug the device when you need to.
About the Battery
Use a specified charger approved by the manufacturer.
This product uses a Lithium-Ion battery. Do not use it in a humid, wet and/or
corrosive environment. Do not put, store or leave your product in or near a heat
source, in a high temperature location, in strong direct sunlight, in a
microwave oven or in a pressurized container, and do not expose it to
temperatures over 60
corrosive environment. Do not put, store or leave your product in or near a heat
source, in a high temperature location, in strong direct sunlight, in a
microwave oven or in a pressurized container, and do not expose it to
temperatures over 60
ºC (140ºF). Failure to follow these guidelines may cause
the Lithium-Ion battery to leak acid, become hot, explode or ignite and cause
injury and/or damage. Do not pierce, open or disassemble the battery. If the
battery leaks and you come into contact with the leaked fluids, rinse
thoroughly with water and seek medical attention immediately. For safety
reasons, and to prolong the lifetime of the battery, charging will not occur at
low (below 0
injury and/or damage. Do not pierce, open or disassemble the battery. If the
battery leaks and you come into contact with the leaked fluids, rinse
thoroughly with water and seek medical attention immediately. For safety
reasons, and to prolong the lifetime of the battery, charging will not occur at
low (below 0
ºC/32ºF) or high (over 45ºC/110ºF) temperatures.
THE LITHIUM-ION BATTERY CONTAINED IN THE PRODUCT MUST
BE RECYCLED OR DISPOSED OF PROPERLY. USE 3200 GO ONLY
WITH THE SUPPLIED DC POWER LEAD AND AC ADAPTER FOR
BATTERY CHARGING.
BE RECYCLED OR DISPOSED OF PROPERLY. USE 3200 GO ONLY
WITH THE SUPPLIED DC POWER LEAD AND AC ADAPTER FOR
BATTERY CHARGING.
Important instructions (for service personnel only)
Caution: Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.
Dispose of used batteries according to the instructions.
Replace only with the same or equivalent type recommended by the
manufacturer.
manufacturer.