Behringer Xenyx Q502USB Benutzeranleitung

XENYX Q1202USB/Q1002USB/Q802USB/Q502USB User Manual

Fig. 2.7: FX send/return connectors

Fig. 2.8: FX send/return controls

STEREO AUX RETURN
Q802USB only: the STEREO AUX RETURN connectors are used to bring the 

output of the external effects device (whose input is derived from the aux sends) 

back into the console. You can instead use these connectors as additional inputs, 

but any effects device will then have to be brought back into the console via a 

normal stereo channel. This does, however, give you the ability to use the channel 

EQ on the effects return signal if you wish.

If only the left connector is used, the AUX RETURN automatically operates in 

mono. Use the AUX RETURN control to determine how much of the effects signal 

is sent to the main mix.

FX SEND
The FX SEND output (does not apply for Q502USB) should be connected to the 

input of an external effects unit. The post-fader FX signal you created using 

the input channel FX controls is sent to the effects unit via the FX SEND ouput. 

Use the FX SEND control of the main section to adjust the overall send level 

(Q1002USB and Q1202USB only).

Fig. 2.9: Monitor/main mix connectors

Fig. 2.10: Monitor control and main mix fader

PHONES/CONTROL ROOM
The stereo PHONES jack (at the top of the connector panel) is where you connect 

headphones. The unbalanced CTRL ROOM OUT jacks carry the summed effects 

and main mix signals. The PHONES/CONTROL ROOM control adjusts the level of 

both headphones and main monitor outputs. The Q502USB is not equipped with 

control room outputs.

MAIN MIX
The MAIN OUT connectors are unbalanced mono jacks. The main mix signal 

appears here at a level of 0 dBu. The MAIN MIX fader adjusts the volume of these 

outputs. The XENYX Q802USB and Q502USB mixing consoles feature a rotary 

control for this purpose.

2-TRACK INPUT
The 2-TRACK INPUT s are used to bring an external signal source (e.g. CD player, 

tape deck, etc.) into the console. They can also be used as a standard stereo line 

input, so the output of a second XENYX or BEHRINGER ULTRALINK PRO MX882 can 

be connected.

Fig. 2.11: 2-TRACK input/output

Alternatively the line or tape output of a hi-fi amplifier with source selection 

switch could also be hooked up here, allowing you to easily listen to 

additional sources.

2-TRACK OUTPUT
These connectors are wired in parallel with the MAIN OUT and carry the main mix 

signal (unbalanced). Connect the 2-TRACK OUTPUT to the inputs of your recording 

device. The output level is adjusted via the high-precision MAIN MIX fader or 

rotary control (Q802USB and Q502USB).