Brocade Communications Systems 53-1002580-01 Benutzerhandbuch

Installing an Optional SFP Transceiver

2

Installing an Optional SFP Transceiver

FIGURE 13

INSTALLING AN OPTIONAL SFP TRANSCEIVER

These switches support SFP-compatible transceivers. To install an SFP transceiver, do the 
following:

1. Consider network and cabling requirements to select an appropriate SFP transceiver type.

2. Insert the transceiver with the optical connector facing outward and the slot connector facing 

down. Note that SFP transceivers are keyed so they can only be installed in one orientation.

3. Slide the SFP transceiver into the slot until it clicks into place.

NOTE
SFP transceivers are hot-swappable. The switch does not need to be powered off before installing 
or removing a transceiver. However, always first disconnect the network cable before removing a 
transceiver.

NOTE
SFP transceivers are not provided in the switch package.

Grounding the Chassis

Before powering on the switch, ground the switch to earth as described below.

1. Ensure that the rack on which the switch is to be mounted is properly grounded and in 

compliance with ETSI ETS 300 253.

2. Ensure that there is a good electrical connection to the grounding point on the rack (no paint or 

isolating surface treatment).

3. Disconnect all power cables to the switch.