Brother MD-611 Benutzeranleitung

 

 

22

BAS-300G, BAS-311G, BAS-326G 

Do not touch any of the moving parts or press any objects against the machine while winding the lower thread.

 

Injury or damage to the sewing machine may result.

 
1.  Place the bobbin onto the bobbin winder shaft (1). 
2.  Thread the thread as shown in the illustration, wind the 

thread around the bobbin several times, and then press 
the bobbin presser arm (2). 

3.  Turn on the power switch. 
4.  Depress the foot switch to the 2nd step.   

(If using a two-pedal foot switch, lower the work clamp 
before depressing the start switch.） 
The feed mechanism will move to the home position. 

5.  Check that the needle does not touch the work clamp, 

and then while pressing the TENSION/WIND key (3), 
depress the foot switch to the 2nd step. 
(If using a two-pedal foot switch, lower the work clamp 
before depressing the start switch.) 

6.  Release the TENSION WIND key (3) after the machine 

starts operating, and keep depressing the foot switch 
until the lower thread stops being wound onto the 
bobbin. 

(If you release the foot switch before winding is 
complete, and then depress it again while pressing the 
TENSION/ WIND key (3), winding will start again.) 

7.  Once winding of the set amount of lower thread (80 - 

90% of the bobbin capacity) is completed, the bobbin 
presser arm (2) will return automatically. 

8.  Remove the bobbin, hook the thread onto the knife (4), 

and then pull the bobbin in the direction of the arrow to 
cut the thread. 

 
 
 
 
 
 

Adjusting the bobbin winding amount 
Loosen the screw (5) and move the bobbin presser (6) to 
adjust. 
 
 
 
 
 
 
 
 
 
 

If the thread winds onto the bobbin unevenly 
Loosen the set screw (7) and move the bobbin winder 
tension assembly (8) up and down to adjust. 
*  For case A, move the bobbin winder tension assembly 

(8) down, and for case B, move it upward. 

 
 
 
 

4471Q 

For case B

For case A

4432Q 

4430Q

4431Q 

4429Q