Bosch sHe58C Benutzerhandbuch

Rinse Agent Dispenser
open the rinse agent dispenser by lifting the tab with your thumb as shown in

 figure 17.

NOTE: the dishwasher indicates low rinse agent by showing the symbol  

 in the 

countdown display.
add liquid rinse agent to the dispenser as shown in figure 18 until the rinse agent reservoir 
is full. Wipe up any excess rinse agent that puddles when the dispenser reservoir is full.
NOTE: After filling the rinse agent dispenser, the  indicator light will go out in a few 
minutes after the dishwasher door is shut (select models only).

always make sure your dishware is dishwasher safe. refer to the 

Dishware Materials 

section of this manual for guidance.

Wash Cycles

takes the guesswork out of cycle selection. sensors adujst cycle length, temperature and 
water changes based on the soil load. this cycle is appropriate for pots and pans.

Cleans items having baked-on or hard dried-on food soils. these items may require soaking 
or hand scouring.

takes the guesswork out of cycle selection. sensors adujst cycle length, temperature and 
water changes based on the soil load. this cycle is appropriate for mixed loads.

thoroughly cleans large loads having loosely attached normal soiling.

for delicate or heirloom dishwasher and silverware or other special items. always make 
sure that the items are dishwasher safe. refer to the Materials section of this manual for 
further information. Hand washing may be the best treatment of such items.

for lightly soiled items with easy to remove food soils.

allows you to rinse the food soil off of a partial load and hold them in the dishwasher until 
there is a full load.

Wash Cycle Options

in the power scrub plus, regular and auto Wash cycles you can reduce the energy and 
water consumption when washing small, lightly soiled loads that fill approximately half of 
the dishwasher’s capacity. to activate, select the Half load button in addition to the power 
scrub plus, regular or auto Wash cycle button.

This option allows you to save energy and water by washing loads small enough to fill the 
top rack only. to activate, select the top rack only button in addition to a cycle. When 
using the top rack only feature, dishes should only be loaded in the top rack.

With this option you can raise the temperature of the rinse water and increase the drying 
time which will result in improved drying. 

to activate: 

·  press and hold the left “Cancel Drain” button, then press and hold the on/off button.