Walker MW 15 HP Benutzerhandbuch

40

IMPORTANT: ALWAYS  use genuine factory re-
placement parts.  Substitute parts CAN result in
product malfunction and possible injury to the oper-
ator and/or others.

There are two (2) individual belts:

•

Ground Drive Belt 

•

PTO Drive Belt (3 Groove Power Band)

The belts may be removed and replaced using the
following procedures:

1.

Remove the two mounting bolts holding the
PTO belt guide in place and loosen the front
mounting bolts of PTO actuator assembly (as
shown).  Remove belt guide.  Remove nuts on
the front of brake band and remove.

2.

Unhook spring and unbolt actuator clevis at-
tached to the PTO gearbox assembly.  Pull
gearbox assembly to the rear and remove belt. 

3.

Install the PTO drive belt by reversing removal
procedure.

NOTE: The PTO drive belt must be removed for re-
moval of the ground drive belt.

1.

Relax the belt by releasing spring tension from
the ground drive belt idler arm.

2.

Slide the belt over both transaxle pulleys and
feed it toward the back of the mower.

3.

Install ground drive belt by reversing removal
procedure.

Ground Drive

Idler Pulley

Ground

Drive Belt

Remove Spring and

Linkage

Remove Mounting Bolts and

Loosen Front Bolts

(not shown)

PTO

Drive Belt