Wyse Network Router 1 Benutzerhandbuch

Setting Up the Thin Client

• User defined display setting - Select this option and select the resolution and refresh 

rate supported by your monitor (all combinations are allowed):
• Resolution list selections include:

640 x 480 
800 x 600 (default)
1024 x 768 
1280 x 1024 
1600 x 1200

• Refresh rate list selections include:

• Usage Help area - Contains brief instructions for using the Display Setup dialog box 

and running the test. No operator entry can be made in this box. Make note of the 
instructions in the area regarding v-key reset usage in case of display failure.

The Serial Setup dialog box allows configuration of the ports used for modem dialup mode 
and serial communications.

A serial port can be used for modem access to a network (intranet or Internet) through a 
dial-up server (for example, a Microsoft Remote Access Server, or an ISP supporting 
industry-standard protocols) as an alternative or supplement to using the thin client 
network port (see “Using and Configuring Access Connections” ). For this use, a USB 
modem or a converter and a serial modem must be connected to the thin client USB port. 
A USB hub may be employed to support up to two USB ports if another USB connector is 
not available on your thin client (see "Configuring Dialup Modem Access"). For supported 
converters, refer to the Wyse Web site.

With Wyse software version 4.2 and later, ICA virtual COM driver supports 
synchronizing with Palm devices over a serial port.