Woodstock SHOP FOX W1736 Benutzerhandbuch

Seite von 28
-12-
SET 
UP
W1736 Overarm Router
The adapters included with the Model W1736 are 
designed for most common sizes of Makita, Milwaukee, 
Bosch, Porter-Cable, and Dewalt routers that have 
detachable bases.
To install a router motor into the overarm router 
assembly, do these steps:
1.  Remove your router motor from its base and mea-
sure the diameter of the router motor or the base 
from which it was removed. (If your router size does 
not closely match any of the adapters, you may not 
be able to safety mount your router motor on the 
Model W1736.)
2.  Slide the correct size adapter over the router 
motor, as shown in 
Figure 9, aligning any pins in 
the router with the slots in the adapter and making 
sure that the adapter lip is toward the top part of 
the router. 
 
Note: The adapter must have a snug fit all the way 
around the router body or it will not secure to the 
housing properly. Refer to 
Figure 10 to ensure a 
proper fit.
3.  Insert the router motor/adapter assembly into the 
housing on the overarm router assembly.
4.  Using a 6mm hex wrench, tighten the cap screw at 
the front of the housing to secure the router motor 
(see 
Figure 11).
5.  Check that the router motor is tightly secured in the 
housing by pulling on it to see if it can be pulled out 
of the housing.
•  If the router motor is loose or can be pulled out 
of the housing, then it is not fastened correctly 
or installed with the correct adapter. Remove the 
router and try refastening it, or remeasure your 
router and ensure that you are using the correct 
adapter.
•  If the router motor cannot be pulled out by hand, 
then proceed with the rest of the setup process.
Note: If the router is contacting the table in the down 
position, adjust the plunge depth knob (see 
Page 3) so 
the router will not contact the table in the down posi-
tion.
Installing Router
Figure 9. Fitting correct size adapter onto 
router motor.
Figure 11. Router motor secured in 
overarm assembly.
Cap 
Screw
Figure 10. Illustration of a good vs. bad 
fit between router motor and adapter.
������
�����
�������
��������
������
�����
�������
�������