Wow Wee Roboremote 8000 Benutzerhandbuch

Battery details

This section describes battery requirements and installation procedures for Roboremote.

Roboremote uses 3 x size “AAA” sized batteries (not included). 

Installing or changing batteries in Roboremote:

1.  On the back side of Roboremote, using
  a Phillips screwdriver (not included),
  remove the screw on the battery
  compartment cover and then remove
  the battery compartment cover.

2.  Remove the old (if any) 3 x “AAA” batteries 
  from the battery compartment, and replace
  with fresh batteries.

 Make sure you align the polarities

and positions of the batteries with corresponding
markings inside the battery compartment. 

3.  Replace the battery compartment cover
  and replace the screw that holds it in place. 

• Use only fresh batteries of the required size and recommended type.
• Do not mix old and new batteries, different types of batteries [standard (Carbon-Zinc),    

 

  alkaline or rechargeable] or rechargeable batteries of different capacities.
• Rechargeable batteries are only to be charged under adult supervision.
• Respect the correct polarity, (+) and (-) as indicated.
• Do not try to recharge non-rechargeable batteries.
• Do not dispose of batteries in fire. Batteries might explode or leak.
• Replace all batteries of the same type/brand at the same time.
• The supply terminals are not to be short-circuited.
• Remove exhausted batteries from the toy.
• Batteries should be replaced by adults.
• Remove batteries if the toy is not going to be played with for some time.
• Rechargeable batteries are to be removed from Roboremote before being charged.

3

Battery details