Wayne-Dalton 9800 Benutzerhandbuch

side of the jamb, fit the weatherstrip up tight against the temporarily attached weatherstrip in 

the header and flush with the inside edge of the jamb. Temporarily secure the weatherstrip 

with equally spaced nails. Repeat for other side. This will keep the bottom section from falling 

out of the opening during installation. Equally space nails approximately 12” to 18” apart.
For other track systems: For the header, align the weatherstrip 1/8” to 1/4” inside the header 

edge, and temporarily secure it to the header with equally spaced nails. Starting at either 

side of the jamb, fit the weatherstrip up tight against the temporarily attached weatherstrip in 

the header and 1/8” to 1/4” inside the jamb edge. Temporarily secure the weatherstrip with 

equally spaced nails. Repeat for other side. This will keep the bottom section from falling out 

of the opening during installation. Equally space nails approximately 12” to 18” apart.
headroom requirement: Headroom is defined as the space needed above the top of the 

door for tracks, springs, etc. to allow the door to open properly. If the door is to be motor 

operated, 2-1/2” (64 mm) of additional headroom is required.
Backroom requirement: Backroom is defined as the distance needed from the opening 

back into the garage to allow the door to open fully.
Backroom requIrements

6’0” to 7’0”

6” Low Headroom

102” (2591 mm)

125” (3175 mm)

7’1” to 8’0”

6” Low Headroom

114” (2896 mm)

137” (3480 mm)

6” Low Headroom

6” (152 mm)

Weatherstrips

Level header

Finished 

Door width

Jambs

Backroom

Plumb 

jambs

Finished 

Door

Height

Nail

Headroom

Header board 2”x 6” 

lumber preferred

Suitable mounting surface 

2”x 6” lumber minimum

Min. Side 

room 

Clearance 

is 3 1/2”

Min. Side 

room 

Clearance 

is 3 1/2”

Fully Adjustable track

Weather 

seal

Jamb

1/8” to 1/4”

Door 

Stop

Jamb

1/8” to 1/4”

Door 

Stop

Jamb

Weather 

seal

Jamb

Quick Install track

4