Maretron MBB100 Benutzerhandbuch

 

 

 

 

When unpacking the box containing the Maretron MBB100, you should find the following items: 
 

•  1 – MBB100 Maretron Black Box Vessel Monitoring and Control 

•  2 – Mounting Brackets 

•  1 – Short Screw Set (Used for Mounting Bracket) 

•  1 – AC Power Cord 

•  1 – AC Power Supply 

•  1 – Rubber Feet/Long Screw Set 

•  1 – MBB100 User’s Manual 

•  1 – N2KView

®

 Documentation CD-ROM 

•  1 – Warranty Registration Card 

 
If any of these items are missing or damaged, please contact Maretron. 

The MBB100 must be mounted in an indoor location. 

The MBB100 can be mounted to a wall or other flat surface with the included mounting brackets. 
 
2.6.1 Mounting the System with Mounting Brackets 
To mount the MBB100 onto a wall or some other surface using the two mounting brackets, please 
follow the steps below. 
 
Step 1:  Turn the MBB100 over. 
 
Step 2:  Align the two retention screws holes in each bracket with the corresponding retention screw 

holes on the sides of the MBB100 bottom surface (marked in yellow in Figure 2). 

 
Step 3:  Secure the brackets to the MBB100 by inserting two retention screws into each bracket (see 

Figure 2). 

 
Step 4:  Drill holes in the intended installation surface. 
 
Step 5:  Align the mounting holes in the sides of the mounting brackets with the predrilled holes in the 

mounting surface. 

 
Step 6:  Insert four retention screws, two in each bracket, to secure the MBB100 to the wall.