LogTag Recorders LogTag Analyzer Temperature Recorder Benutzerhandbuch

Once a LogTag has been successfully configured for use it is ready to be started. To start 
a LogTag simply press and hold the START MARK button on the LogTag until both the OK 
and Alert lights alternately flash on and off.  

You can also have the LogTag record an "inspection" mark at any time while it is 
recording, simply by pressing and holding the START MARK button on the LogTag until 
both the OK and Alert lights flash on and off at the same time. You may have the LogTag 
record as many inspection marks as you want while it is recording, however only one 
inspection mark can be recorded per reading. In other words, if your LogTag is configured 
to take readings at 15 minute intervals, inspection marks can be recorded at intervals of 
15 minutes or more. If the LogTag has finished recording then pressing the START MARK 
button will have no effect until after the LogTag has been prepared for next use. 

The red light on the LogTag, also called the Alert light, will regularly flash to indicate that 
a preset alert condition has been met and/or exceeded.  

While the LogTag is recording after being started, the green light on the LogTag, also 
called the OK light, will regularly flash every 4 seconds to indicate that it is still recording. 
Once the LogTag has finished recording the green light will regularly flash every 8 
seconds. However, if a preset alert condition has been met and/or exceeded then only the 
Alert light will flash, even if the LogTag has finished recording.