Leibherr USA Refrigerators and freezers for integrated use, door-on-door HRB 1110 HF 851 Benutzerhandbuch
Note
u
In case of disassembly: Press back the dark grey ring on
the plug-in elbow and pull out the hose at the same time.
u
Pull the tray
Fig. 33 (4)
out until it catches.
u
Secure the module
with
4
screws
Fig. 33 (5)
through the
recesses in the front
and directly through
the module in the
back.
Fig. 33
u
Place the tray cover
Fig. 35 (3)
in position.
Fig. 34
Fig. 35
u
Insert the water filter
Fig. 35 (6)
and turn it approximately
100° to the right until it locks into position.
u
Place the cover
Fig. 35 (2)
on the filter.
u
Slide the tray in.
u
Write the date of the next filter replacement on the
supplied adhesive label and affix it to the module.
u
Make sure the filter is leak-tight and no water is coming
out.
Note
New water filters may contain particulate matter and must
be rinsed through before use.
u
To achieve this, do not consume or use the ice cubes that
are produced within 72 hours after the filter is replaced.
w
The water filter is now ready for use.
8 Connecting the appliance
WARNING
Electrical shock hazard!
u
Start-up should only take place once the appliance has
been installed according to these instructions.
u
Electrically ground appliance.
u
Do not ground to a gas pipe.
u
Check with a qualified electrician if you are not sure the
appliance is properly grounded.
u
Do not have a fuse in the neutral or grounding circuit.
u
Do not use an extension cord, power bar or a multiple
socket adapter.
u
Do not use a power cord that is frayed or damaged.
WARNING
Electrical shock hazard!
This appliance is equipped with a three-prong (grounding)
polarized plug for your protection against possible shock
hazards. Electrical Grounding Required.
u
Do not remove the round grounding prong from the plug.
u
Do not use a two-prong grounding adapter.
- Wait 30 minutes up to 1 hour after installation before you
plug in the appliance. This allows the refrigerant and
system lubrication to reach equilibrium.
- Make sure incoming voltage is the same as the appliance
rating. A 110-120 Volt, 60 Hz, 15 Amp electrical supply
(20 Amp for side-by-side installations) circuit that is
controlled by a circuit breaker or fuse is required.
- We recommend using a dedicated circuit for this
appliance to prevent electrical overload.
- Follow all Federal, State and local electrical, fire and
building codes and ordinances when installing the
receptacle and / or the appliance.
- In some communities, a wall switch is required to turn
power to the appliance ON and OFF.
- To reduce the risk of fire, electric shock, or personal
injury, installation work and electrical wiring must be
done by a qualified electrician in accordance with all
applicable codes and standards, including fire-rated
construction.
- You are advised to clean the appliance before switching
it on the first time .
- The top of the electric outlet must be located within
82-5/8 in. (2100 mm) from the top of the base in the
cabinet.
Connecting the appliance
14