Maytag MVWP475EW Benutzeranleitung

Washer won’t run or fill, 

washer stops working 

or wash light remains 

on (indicating that the 

washer was unable to fill 

appropriately) (cont.)

Check proper electrical supply.

Plug power cord into a grounded 3 prong outlet.
Do not use an extension cord.
Ensure there is power to outlet.  
Reset a tripped circuit breaker. Replace any blown fuses. 

NOTE: If problems continue, contact an electrician.

Normal washer operation.

Lid must be closed for washer to run.
Washer will pause during certain phases of cycle. Do not  

interrupt cycle.

Washer may be tightly packed.

Remove several items, rearrange load evenly in basket, and add 

detergent. Close lid and press START/Pause.
Do not add more than 1 or 2 additional items after cycle has started 

to avoid tightly packing or unbalancing.

Washer not draining/ 

spinning, loads are  

still wet or spin light remains 

on (indicating that the 

washer was unable to pump 

out water within 10 minutes

Small items may have been caught 

in pump or between basket and tub, 

which can slow draining. 

Empty pockets and use garment bags for small items.

Use a cycle with a low spin speed.

Cycles with lower spin speeds remove less water than cycles  

with high spin speeds. Use the recommended cycle/speed spin for 

your garment. To remove extra water in the load, select Drain & Spin. 

Load may need to be rearranged to allow even distribution of the 

load in the basket.

The washer may be tightly packed  

or unbalanced.

Tightly packed or unbalanced loads may not allow the washer  

to spin correctly, leaving the load wetter than normal, leading 

to longer cycle times and longer dry times. Evenly arrange the 

wet load for balanced spinning. Select the Drain & Spin cycle 

to remove excess water. See “Using Your Washer” for loading 

recommendations.

Washer not performing as expected (cont.)
Washer won’t run  

or fill, washer stops  

working or wash light  

remains on (indicating that 

the washer was unable to fill 

appropriately)

Check for proper water supply.

Both hoses must be attached and have water flowing to inlet valve.
Both hot and cold water faucets must be turned on. 
Check that inlet valve screens have not become clogged.
Check for any kinks in inlet hoses, which can restrict water flow.

First try the solutions suggested here or visit our website at www.maytag.com/product_help - 

In Canada www.maytag.ca for assistance and to possibly avoid a service call.