Manualsbrain.com
  1. Handbücher
  2. Marken
  3. Fire Magic
  4. E660S4E1N71
  5. Anleitung Für Quick Setup

Fire Magic E660S4E1N71 Anleitung Für Quick Setup

Download
Seite von 2
REV 2 - 1110241416
L-C2-336
4-Grill Setup
Fig. 4-1
Cooking Grid
Flavor Grid 
(not with IR)
Backburner 
cover
Warming 
rack
Cotter 
Pin
Rotisserie 
rod storage 
ring
6-Propane Safety
Gas Cylinders
IMPORTANT:  READ AND FOLLOW ALL WARNINGS PROVIDED WITH THE PROPANE-GAS CYLINDER.
 
READ ALL SAFETY INSTRUCTIONS AND WARNINGS REGARDING THE USE OF PROPANE GAS FOUND IN 
YOUR OWNERS MANUAL.
Sideburner 
lid
Parts Placement Checklist
Place the following items according to their position and orientation in 
Fig. 4-1:
Flavor grids, cooking grids, heat zone dividers, backburner cover, 
warming rack, meat probe. 
Leave pre-installed E-burners in place to maintain proper alignment.
Backburner Cover
Hook the backburner cover over the top of the backburner to protect 
the backburner from grease, dust and dirt when it is not in use. Remove 
before use.
Warming Rack
The warming rack comes pre-installed. Remove zip ties before use. 
Consult the owner’s manual to remove or replace.
Shelf/Sideburner (if equipped)
Align the four (4) holes in the shelf with the four (4) holes in the side of 
the cart while aligning and engaging the burner venturi with the orifi ce 
(Fig. 4-2). Insert the four (4) screw (provided) into the holes and tighten. 
Connect the spark wire to ignitor electrode (Fig. 4-2). Open sideburner 
lid, set cap on burner, and set grid into shelf.
Screws
Ignitor 
electrode
Air shutter
Orifi ce
Spark 
wire
Fig. 4-2
Venturi
Note:  For infrared burner equipped 
grills; see detailed instructions 
included in your owners manual.
Meat probe
Fig. 5-2
Left main burner 
control knob
Right
main burner 
control knob
Digital thermometer
Center right main burner
control knob
Center left main 
burner
control knob
Smoker drawer 
burner control 
knob
Power hood control 
switch (if equipped)
Right backburner
 control knob 
(if equipped)
Left
backburner
 control knob 
(if equipped)
Pull-out drip 
tray
Meat probe
Wood chip 
tray
Drip tray 
liners
Drip tray (with 
lighting instructions)
5-Test
1.  Open the lid and remove any cover(s) of the burner(s) to be lit.
2.  Turn all gas control knobs to the OFF position.
3.  Turn the gas-supply valve on.
4.  Depress the desired control knob, and while pressing turn it counterclockwise 
to the HI LIGHT position. Once the burner lights, release the control knob. 
(Repeat this step for each additional burner.)
CAUTION: If burner does not light within 5 seconds, IMMEDIATELY depress the 
knob and turn it to the OFF position. Wait 5 minutes before repeating 
step 4. If the burner does not light after repeated attempts, refer to the 
Lighting Instructions in your Owners Manual.
Door
Drawers
Sideburner
control knob
WHEN OPERATING THIS 
APPLIANCE WITH PROPANE, ALL 
INSTRUCTIONS AND WARNINGS 
MUST BE OBSERVED. FAILURE TO 
DO SO MAY RESULT IN A FIRE OR 
EXPLOSION CAUSING SERIOUS 
INJURY OR DEATH.
The master switch (Fig. 5-2) controls 
the power to all lights, igniters, and the 
thermometer. It allows the power to be 
turned on or off for safety and convenience. 
The switch will need to be turned on prior to 
each grill use, and turned off after each use.
For your convenience and safety; 
when the control knob is in the 
ON position, the gas fl ow indicator 
will change from blue to red. (Red 
indicates gas fl ow.) See Fig. 5-1.
Fig. 5-1 - Burner valve control knob
OFF
HI
LIGHT
LOW
T
O
 TURN OFF
T
O
 TURN 
ON
Read setting
here
HIGH to 
LIGHT
Read setting here 
(OFF position shown)
To
 Turn 
OFF
To
 T
urn 
ON
Use
HI (high) 
to light
Press 
knob in 
to turn
Gas Flow 
Indicator
Master 
switch
    E-burner 
*
 
(comes pre-
installed) 
*
 The burner  ports 
and carry-over slots 
must be kept clean to 
ensure proper ignition 
and operation.