Perlick HP24TS31R2A Installationsanweisungen

PERLICK RESIDENTIAL INSTALLATION MANUAL FOR BEER DISPENSING EQUIPMENT

10

perlick.com

Before tapping, make sure the beer faucet is closed. To 

tap a keg, insert the coupler into the neck of the barrel. 

Turn the coupler clockwise until it stops (about an 1/8 

turn), then push down on the top of the coupler and 

again turn clockwise until it stops. Your barrel is now 

tapped. Open the CO2 valve on the regulator as well as 

the valve on the manifold if used. 

1.  Remove the blue plug from the regulator fitting, but do 

not remove the carbonic washer.

2.  Screw regulator onto gas cylinder valve. Tighten with 

wrench until vertically straight. Be sure that the shut-off 

valve on the regulator is in the OFF (horizontal) position.

3.  Place screw clamp over the end of red line and push onto 

regulator tail piece. Tighten clamp with a screwdriver. 

4.  Turn regulator adjusting screw counterclockwise until 

it turns freely.

5.  Turn hand valve counter-clockwise on the CO2 cylinder 

to the fully open position.

6.  Turn regulator adjusting screw clockwise until desired 

pressure is reached (approximately 12-15 lbs.) Tighten 

stop nut on adjusting screw.

7.  Open shut-out valve on bottom of regulator.
8.  Dilute a small amount of liquid dishwashing soap and 

rub the soapy mixture around connections. If bubbles 

appear, tighten connection.