Gaggenau AI442720 Installationsanleitung

Seite von 60
10
Safety clearances
9
WARNING
Risk of fire
Grease deposits in the grease filter may catch 
fire. The specified safety distances must be 
observed in order to prevent an accumulation of 
heat.   Observe the specifications for your cooking 
appliance.  If gas and electric cooktops are 
operated together, the largest specified distance 
applies.
Only one side of the appliance may be installed 
directly next to a high-sided unit or a wall.  The 
distance between the appliance and wall or high-
sided unit must be at least 2" (50 mm).  
The minimum distance between the supporting surface 
for the cooking equipment on the hob and the lowest 
part of the range hood must be not less than 30 " 
(760 mm) from electric cookers and 30 " (760 mm) from 
gas or mixed cookers.
If the instructions for installation for the gas hob specify 
a greater distance, this must be adhered to.
Installation
Transport securing device
The supporting frame is secured for transport using 
self-tapping screws. Remove these self-tapping screws 
before installation.
Fitting the upper support frame
1
Before installation, establish the total height of the 
support frame.
Note: The height of the support frame can be 
adjusted in steps of ¾" (20 mm).
2
Mark the positions of the six screws on the ceiling.
Note: Ensure that the support frame is in the 
correct position.  The appliance has one control 
panel on the open side of the support frame. The 
other control panel is located on the opposite side.
3
Drill the holes and push in the wall plugs so that 
they are flush with the wall.
4
Use four screws to fit the reinforcement plate to the 
inside of the support frame.
5
Use six screws to fasten the upper support frame to 
the ceiling.
!
!
 
 
DERYHHOHFWULF
VXUpOHFWULTXH
VREUHHOpFWULFR
DERYHJDV
VXUJD]
VREUHJDV