American Range ARR448GDGRL Benutzung Und Pflege
13592 Desmond St., Pacoima, CA 91331 818.897.0808 tel 888.753.9898 toll free www.americanrange.com
8
Cuisine & Performer Ranges
Use & Care Manual
• Do not remove protective packaging until you are ready to perform the installation.
• Do not remove the protective wrapping from the product control panel until the product is installed.
• Caution - the appliance is heavy. Use extreme care when handling!
• Use proper equipment to move products.
• Any openings in the wall and in the floor behind or under the oven must be sealed.
• Do not use an extension cord with this appliance. Such use may result in fire, electrical shock or other personal injury.
• Installation of this appliance should be performed by qualified, licensed contractors.
• To remove the packaging, first remove the staples located at the bottom perimeter of the corrugated cardboard cover.
• Remove the corrugated cardboard carton by lifting it off the product and remove the inner packing.
• Detach the product from the metal anchor strip by removing the attachment screw.
• Confirm available access to adequate power and gas. See specifications & electrical requirements table.
• Fill out the inside cover of this installation manual with the requested data. Model Number and Serial Number can be found
on the plate located underneath the control panel on the front of the appliance.
INSTALLATION INSTRUCTIONS
Do not use the handle or oven door to lift the oven. Remove pull down door before installation to ensure that it is not used to
lift the unit. Make sure the hinge catch is fully open or closed before removing door to prevent injury to hands and/or fingers.
lift the unit. Make sure the hinge catch is fully open or closed before removing door to prevent injury to hands and/or fingers.
WARNING
!
For optimal performance, the range should be installed away from drafts that may be caused by doors, windows, and heating
and air conditioning outlets.
and air conditioning outlets.
IMPORTANT
WARNING
!
Important - The maximum depth of the overhead cabinets installed on either side of the hood is 13".
CABINET PREPARATION
• This Range is a free standing unit.
• When installed, Range door must be beyond face of cabinet and cannot be installed flush.
• Check cabinet materials to be sure they can be used in proximity of the Range.
• The maximum depth of overhead cabinets installed on either side of the hood is 13".
• Any openings in the wall behind the Range and in the floor under the Range must be sealed.
• When there is less than 12" clearance between combustible material and the back edge of the Range above the cooking surface,
a backguard must be installed.
• When clearance to combustible material is over 12" no backguard is necessary.
• Backguards must be ordered separately.