Maytag MEDB835DW Benutzung Und Pflege

11

Changing the Sensor Cycle settings  

to increase drying time

If all your loads on all Sensor Cycles are consistently not as 

dry as you would like, you may change the default settings to 

increase or decrease the default dryness level.
Your sensor drying settings can be adjusted to adapt to 

different installations, environmental conditions, or personal 

preference. This change is retained and will affect all of your 

Sensor cycles, not just the current cycle/load. There are 5 

drying settings, which are displayed using the time display:

0  Much wetter clothes, 30% less drying time.

1  Slightly wetter clothes, 15% less drying time.

2  Factory preset dryness level.

3  Slightly drier clothes, 15% more drying time.

4  Much drier clothes, 30% more drying time.

To change the drying settings:

NOTE: The settings cannot be changed while the dryer is 

running or paused. The dryer must be in standby mode (power 

is off) to adjust the default settings.

1.  Before starting a cycle, touch and hold DRY LEVEL for  

6 seconds. 

2.  Touch DRY LEVEL to select the dryness level shown in the 

time display: 0, 1, 2, 3, or 4. 

3.  Touch START to save the new dryness level setting. 

USING THE DRYING RACK

To obtain a drying rack for your dryer, order by calling  

1-877-944-7566. You will need your model and serial  

number and the purchase date. Remove and discard any 

packing material before use. 
Use the Drying Rack for items that you do not want to tumble 

dry, such as sweaters and tennis shoes. When you use the 

drying rack, the drum continues to turn, but the rack remains 

stationary.
The drying rack is intended for use with the Timed Dry cycles 

only. The drying rack cannot be used with Automatic cycles.
To use the drying rack:
IMPORTANT: Do not remove the lint screen.
1.  Open dryer door.

USING THE DRYING RACK (cont.)

2.  Align the two hooks on the front of the drying rack with the 

holes in the dryer door opening and press down fully into 

holes. Rest the rear support on the dryer back ledge.

 
3.  Place wet items on top of the drying rack. Allow space 

around items for air to circulate. The drying rack does not 

move, but the drum will rotate; be sure to leave adequate 

clearance between items and the inside of the dryer drum. 

Make sure items do not hang over the edges or between 

drying rack grille.

4.  Close the door.
5.  Select a Timed Dry/Air Only, or Low Temperature cycle. 

Items containing foam, rubber, or plastic must be dried on a 

clothesline or by using the Air Only setting.

6.  When the cycle is selected, the Estimated Time Remaining 

display shows the default time. You can change the actual 

time in the cycle by increasing or decreasing the cycle time.

7.  Start the dryer.
NOTE: Check the lint screen and remove any lint accumulated 

from items dried on the drying rack after the cycle is finished.