Dacor RNRP36GSNGH Installationsanweisungen

Installation Instructions

Removing the Oven Door

• 

Do not attempt to disengage the hinge catches with the 

door(s) removed from the range. The hinge springs could 

release causing personal injury.

• 

Do not lift or carry the oven door(s) by the handle.

NOTE: When installing a backguard, always install it before sliding 

the range into place. See page 6.
To make the range easier to move, remove the door(s) to reduce 

weight.
1.  Open the door to its fully opened position.
2.  Use a pair of needle nose pliers and a flat blade screwdriver 

to rotate the catch over the retaining arm on each hinge.

3.  Lift the oven door to about a 15° angle from the vertical 

position.

4.  Hold the door with both hands just below the handle and pull 

it away from the oven while continuing to lift.

Catch

Retaining arm

Gas Connection

•  Make sure the gas supply valve is off and that the power 

cord to the range is disconnected prior to connecting the 

gas line.

•  Do not apply excessive pressure when tightening gas 

connections and fittings.

•  Do not use Teflon tape or plumber’s putty on gas flex line 

connections.

•  For LP installations, the LP gas tank must have its own 

high pressure regulator. This is in addition to the pressure 

regulator provided with the range.

•  The maximum gas supply pressure to the regulator must 

never exceed 1/2 pound per square inch (psi) or 3.5 kPa.

•  The range and shut-off valve must be disconnected from the 

gas supply piping during any pressure testing exceeding 1/2 

psi (3.5 kPa).

•  The range must be isolated from the gas supply piping by 

closing the shut-off valve during any pressure testing at or 

below 1/2 psi (3.5 kPa).

•  Check all gas lines for leaks as instructed to avoid a fire or 

explosion hazard. Do not use a flame to check for leaks.

NOTE: The gas pressure regulator is pre-set at the factory for the 

type of gas intended for use with the appliance. To verify that the 

appliance is compatible with the type of gas available, check the 

range rating label (see inside cover for location). Ranges intended 

for use with LP gas will have “LP” as a part of the model number. 

Consult your dealer if the range is not compatible with the type of 

gas supplied.

1.  Make sure the gas supply valve is in the off position and that 

power to the range is off.

2.  Connect a flexible gas supply line to the gas shut-off valve 

previously installed on the stub out. The gas line needs to be 

long enough to allow the range to be pulled out for service.

3.  Slide the gas line up through the access holes in the chassis 

and up to the regulator. Move the wires around inside the 

access holes to prevent them from catching on the gas line 

as you push it up.

4.  Connect the gas line to the regulator.
5.  Turn all cooktop control valves to the “OFF” position. Turn on 

the gas supply.

6.  Check all lines and 

connections for 

leaks using a soap 

and water solution.

7.  After verifying that 

there are no gas 

leaks, turn off the 

gas supply valve 

connected to the 

range to the off 

position.

Regulator 

connection