GE AGBS45DEF Handbuch

Seite von 24
24
49-85209-1
Troubleshooting tips ... Before you call for service
TR
OUBLESHOO
TING TIPS
Problem
Possible Cause
What To Do
Top burners do not light 
or do not burn evenly. 
(The front right burner 
is designed to have 
slightly smaller flames 
between the 6 and 9 
o’clock positions. This 
is normal.)
Plug on range is not completely 
inserted in the electrical outlet.
Make sure electrical plug is plugged into a live, properly 
grounded outlet.
Burner slits on the side of the 
burner may be clogged.
Remove the burners and clean them. Check the electrode area 
for burned-on food or grease. See the Care and cleaning of the 
range section.
Improper burner assembly..
Make sure the burner parts are installed correctly. See the Care 
and cleaning of the range section.
Burner flames very 
large or yellow
Improper air to gas ratio.
If range is connected to LP gas, contact the person who 
installed your range or made the conversion.
Surface burners light 
but oven does not
The oven gas shut-off valve may 
have accidentally been moved 
during cleaning or moving.
To check the oven gas shut-off valve, remove the drawer (see 
the Care and cleaning of the range section). For lower oven 
drawer models, remove the rear access panel by unscrewing 
the thumb screws in the upper left and right corners. Look for 
the gas shut-off lever at the back of the range.
Burners do not light
Plug on range is not completely 
inserted in the electrical outlet.
Make sure electrical plug is plugged into a live, properly 
grounded outlet.
Gas supply not connected or 
turned on.
See the Installation Instructions that came with your range.
A fuse in your home may be 
blown or the circuit breaker 
tripped.
Replace the fuse or reset the circuit breaker.
Burner parts not replaced 
correctly.
See the Care and Cleaning of the range section.
Drawer does not slide 
smoothly or drags
The drawer is out of alignment.
Fully extend the drawer and push it all the way in. See the Care 
and cleaning of the range section.
Drawer is over-loaded or load is 
unbalanced.
Reduce weight. Redistribute drawer contents.
Lower broil drawer will 
not work
A fuse in your home may be blown 
or the circuit breaker tripped.
Replace the fuse or reset the circuit breaker.
The oven is self-cleaning.
Wait for the self-clean cycle to finish and the oven to cool.
Controls improperly set.
See the broil drawer section.
Lever is  
shown closed. 
PULL TO OPEN.
Sealed burner models
Thumb screws
Lower oven drawer models