Maytag MDG25PRAWW Installationsanweisungen
4
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
Read and follow the instructions provided with any tools
listed here.
Tools needed
■
8" or 10" Pipe wrench
■
8" or 10" adjustable wrench
■
Flat-blade screwdriver
■
Phillips screwdriver
✮
TORX
®†
20 SECURITY SCREWDRIVER OR BIT
■
Adjustable wrench that opens to 1" (25 mm) or 1" (25 mm)
hex-head socket wrench
hex-head socket wrench
■
Level
■
5/16" socket wrench
■
Utility knife
■
Vent clamps
■
Pipe-joint compound resistant to LP gas
■
Caulk gun and caulk (for installing new exhaust vent)
■
Pliers
■
Putty knife
Parts supplied
Remove parts bag from dryer drum. Check that all parts were
included.
included.
■
Foot boot (4)
■
Dryer foot (4)
■
PD models: Cam for service door lock
PR models: Card reader bezel, card reader wire harness,
hardware
PR models: Card reader bezel, card reader wire harness,
hardware
IMPORTANT: The gas installation must conform with local codes, or in the absence of local codes, with the National Fuel Gas
Code, ANSI Z223.1/NFPA 54 or the Canadian Natural Gas and Propane Installation Code, CSA B149.1.
Code, ANSI Z223.1/NFPA 54 or the Canadian Natural Gas and Propane Installation Code, CSA B149.1.
The dryer must be electrically grounded in accordance with local codes, or in the absence of local codes, with the National
Electrical Code, ANSI/NFPA 70 or Canadian Electrical Code, CSA C22.1.
Electrical Code, ANSI/NFPA 70 or Canadian Electrical Code, CSA C22.1.
†® TORX is a registered trademark of Acument Intellectual Properties, LLC.
W10135154B EnFrv10.qxd:YB70809-10135134A 4/20/10 2:42 PM Page 4