Whirlpool WFE715H0EE Benutzung Und Pflege

The oven light is a standard 40-watt appliance bulb. Before 
replacing, make sure the oven and cooktop are cool and the 
control knobs are in the off position.

1. Unplug range or disconnect power.

2. Turn the glass bulb cover in the back of the oven 

counterclockwise to remove.

3. Turn bulb counterclockwise to remove from socket.
4. Replace bulb, then bulb cover by turning clockwise.
5. Plug in range or reconnect power.

First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid a service call, refer 
to the warranty page in this manual and scan the code there with your mobile device, or visit http://www.whirlpool.com/product_help.

Contact us by mail with any questions or concerns at the address below:

In the U.S.A.:

Whirlpool Brand Home Appliances

 

Customer eXperience Center

 

553 Benson Road

 

Benton Harbor, MI 49022-2692

Please include a daytime phone number in your correspondence.

Power supply cord is unplugged.

Plug into a grounded outlet.

Household fuse is blown or a 
circuit breaker is tripped.

Replace the fuse or reset the circuit breaker. If the problem 
continues, call an electrician.

Range is in Sabbath Mode.

See “Sabbath Mode” section.

The control knob is set 
incorrectly.

Push in knob before turning to a setting.

The range is in Demo Mode.

Demo Mode will deactivate the Warm Zone element. See 
“Demo Mode” in the “Electronic Oven Controls” section.

Cookware that is not the proper 
size.

Use cookware about the same size as the surface cooking 
area, element or surface burner. Cookware should not extend 
more than ½" (1.3 cm) outside the cooking area.

Control knob set to incorrect heat 
level.

See “Cooktop Use” section.

Range is not level.

Level the range. See the Installation Instructions.

The electronic oven control was 
set incorrectly.

See “Electronic Oven Controls” section.

Delay Start was set.

See “Cook Time” section.

The oven control lockout is set.

See the control lock keypad feature in the “Feature Guide” 
section.

The range is in Demo Mode.

Demo Mode will deactivate all heating elements. See “Demo 
Mode” in the “Electronic Oven Controls” section.

Oven door is open.

Close oven door. See “Convection Cooking” section.

Oven temperature calibration 
needs adjustment.

See “Oven Temperature Control” in the “Electronic Oven 
Controls” section.

Temperature has been changed 
to Fahrenheit or Celsius.

See “Fahrenheit and Celsius” in the “Electronic Oven Controls” 
section.

Needs service (oven indicator 
lights are flashing).

See “Control Display” in the “Electronic Oven Controls” 
section. If the indicator light(s) keeps flashing, call for service. 
See cover for contact information.

Power failure (display shows 
flashing time).

Clear the display. On some models, reset the clock, if needed. 
See “Clock” keypad feature in the “Feature Guide” section.

Error code (display shows letter 
followed by number).

Press the CANCEL keypad to clear the display. See “Control 
Display” in the “Electronic Oven Controls” section. If it 
reappears, call for service. See cover for contact information.