Maytag MVWB755DW Installationsanweisungen

Remove tape from washer lid, open lid and remove cardboard 

packing tray from tub. Be sure to remove all parts from tray.

NOTE: Keep tray in case you need to move washer later.

Firmly grasp power cord plug and pull to free from rear panel. 

Gently place power cord over console to allow free access to 

back of washer.

Place hose into standpipe (shown in picture) or over side of   

laundry tub.

IMPORTANT: 4.5" (114 mm) of drain hose should be inside 

standpipe; do not force excess hose into standpipe or lay on 

bottom of laundry tub. Drain hose form must be used.

Drain

hose form

If clamp is not already in place on elbow end of drain hose, 

slide it over end as shown. Squeeze clamp with pliers and 

slide black elbow end of drain hose onto black drain port  

and secure with clamp.

For a laundry tub or standpipe drain, go to step 6. 

For a floor drain, remove the preinstalled drain hose form as 

shown in Step 7. You may need additional parts with separate 

directions. See “Tools and Parts”.