Maytag MGDB855D Gebrauchsanleitung

Gather the required tools and parts before starting installation. The dryer must be 

connected to the cold water faucet using the new inlet hoses. Do not use old hoses.

2' (0.6 m) Inlet hose

5' (1.5 m) Inlet Hose

Rubber washer

Parts needed: 

(Not supplied with dryer)

Pliers

1.   Turn cold water faucet off and remove washer inlet hose.
2.   Remove old rubber washer from inlet hose and replace  

with new rubber washer provided. Inspect hoses to be sure 

rubber washers are in place.

3.   Attach 2' (0.6 m) inlet hose to cold water faucet. Screw on 

coupling by hand until it is seated on faucet.

4.   Using pliers, tighten the couplings with an additional  

two-thirds turn.

  

NOTE: Do not overtighten. Damage to the coupling can result.

5.   Attach “Y” connector to the end of small hose. Screw on 

coupling by hand until it is seated on connector.

6.  

Attach dryer 5 ft (1.5 m) inlet hose ends to the “Y” connector. 

Attach washer cold inlet hose to other side of “Y” connector. 

Screw on coupling by hand until it is seated on connector. 

Using pliers, tighten the couplings an additional two-thirds turn.

NOTE: Do not overtighten. Damage to the coupling can result.

7.   Using pliers, tighten the couplings an additional two-thirds turn. 
  

NOTE: Do not overtighten. Damage to the coupling can result.

8.   Attach other end of 5' (1.5 m) inlet hose to fill valve at bottom 

or top of dryer back panel (depending on model). Screw on 

coupling by hand until it is seated on fill valve connector.

9.  

Using pliers, tighten the couplings an additional two-thirds turn. 

  

NOTE: Do not overtighten. Damage to the coupling can result.

10.  Check that the water faucets are on.
11.  Check for leaks around “Y” connector, faucet, and hoses.

“Y” connector

Your installation may require 

additional parts. To order,  

please contact the dealer  

from whom you purchased  

your dryer or an authorized  

service company.