Frigidaire FFES3015P Benutzeranleitung

Seite von 32
11
Oven vent location
The oven vent is located through the upper front trim and 
visible when the oven door is open. When the oven is on, 
warm air passes through this vent. This venting is 
necessary for proper air circulation in the oven and good 
baking results. Do not block oven vent. Doing so may cause 
cooking failures, fires, or damage to the range. Steam or 
moisture may appear near the oven vent. This is normal.
Removing, replacing, and arranging flat or offset 
oven racks
To Arrange - Always arrange the oven racks when the oven 
is cool (prior to operating the oven).
To Remove - Pull the oven rack straight forward until it 
reaches the stop position. Lift up front of oven rack slightly 
and slide out.
To Replace - Place the oven rack on the rack guides on 
both sides of oven walls. Tilt the front of oven rack upward 
slightly and slide the oven rack back into place. Be sure 
oven racks are level before using.
Type of oven racks
Oven Rack Descriptions
Flat oven racks (or the flat handle oven rack) may be 
used for most cooking needs and may be placed in 
most oven rack positions.
The offset oven rack (some models) provides additional 
stepdown positions from the standard flat rack design. 
The offset design positions the base of the rack about 1/
2 of a rack position lower than the flat rack and may be 
used in most oven rack positions.
To maximize oven cooking space, place the bottom 
oven rack (some models) in the lowest rack position for 
baking or roasting large cuts of meat.
Air circulation in the oven
For best air circulation when baking, allow a space of 2-4 
inches (5-10 cm) around the cookware for proper air circu-
lation. Be sure pans and cookware do not touch each other, 
the oven door, sides, or back of the oven cavity.
Hot air must be able to circulate around cookware for even 
heat to reach the food.
Figure 5:
Do not block oven vent location
Always use pot holders or oven mitts when using the 
oven. When cooking, the oven interior and exterior, oven 
racks and cooktop will become very hot which can cause 
burns.
Protective Liners — Do not use aluminum foil to line the 
oven bottom. Only use aluminum foil as recommended in 
this manual. Improper installation of these liners may 
result in risk of electric shock or fire.
CAUTION
WARNING
Figure 6:
Oven rack types
Remove all oven racks and accessories before starting a 
self-clean cycle. If the oven racks are left in the oven 
during the self-clean cycle, they will lose their special 
coating properties, may turn blue, and no longer slide in 
and out of the oven cavity easily. If your model came with 
porcelain-enameled racks, those may be left in the oven 
during the self-clean cycle.
flat
oven rack
flat handle
oven rack
offset
oven rack
bottom
oven rack
IMPORTANT
BEFORE SETTING OVEN CONTROLS