Frigidaire FFGS3025PS Installationsanweisungen

B. Drill Pilot Holes and Fasten Bracket - Drill a 1/8" 

(0,3 cm) pilot hole where screws are to be located. If 

bracket is to be mounted to the wall, drill pilot hole at 

an approximate 20° downward angle. If bracket is to be 

mounted to masonry or ceramic floors, drill a 3/16" (0,5 

cm) pilot hole 1-3/4" (4,4 cm) deep. The screws provided 

may be used in wood or concrete material. Use a 5/16" 

(0,8 cm) nut-driver or flat head screwdriver to secure the 

bracket in place.

C. Level and position the range - Slide range to its 

final position. Insert the range leveling leg in the anti-tip 

bracket. Visually verify if the anti-tip bracket is engaged. 

Lower the range by adjusting the 4 leveling legs 

alternatively until the range is level. Check if the range 

is level by placing a spirit level on the oven rack. Take 

2 readings with the spirit level placed diagonally; take a 

reading in one direction and then in the other direction. 

Level the range if necessary by adjusting the leveling 

legs.

Range side

 To reduce the risk of tipping of the 

range, the range must be secured to the floor by the 

properly installed anti-tip bracket and screws packed 

with the range. Failure to install the anti-tip bracket will 

allow the range to tip over if excessive weight is placed 

on an open door or if child climbs upon it. Serious injury 

might result from spilled hot liquids or from the range 

itself.

If range is ever moved to a different location, the anti-

tip bracket must also be moved and installed with the 

range.

Instructions are provided for installation in wood or 

cement floor. When fastening to floor, be sure that 

screws do not penetrate electrical wiring, gas line or 

plumbing.

A. Locate the Bracket Using the Template - Locate 

the bracket position (right or left side) by placing the 

template symmetrically to the center of the final range 

position. Mark the location of the screw holes, shown on 

template.