Frigidaire FFED3015P Installationsanweisungen

1.  The range is equipped with an anti-tip bracket 

attached to the back of the range with two screws. 
If countertop thickness is greater than 1/2" (1.3cm), 
relocate anti-tip bracket to the lower position 1/4" 
(6.4 mm) below (see fi gure 4).

2.  Anti-slide brackets Installation (Figure 5):

A. Place the range so that it is about 6" out of the 

cabinet.

B. Insert from below the shoulder screws in the 

bottom bracket (one on each side)

C. Slide the range into its fi nal position.
D. Position the "L" bracket against the side of the 

cabinet so that it is retained by the shoulder 
screws, hold bracket and mark the holes on the 
inside of the cabinet. Drill pilot holes into cabinet 
where you just marked (Caution should be taken 
to avoid drilling through the opposite side of the 
cabinet). Attach the "L" bracket to the cabinet 
with the screws provided (don't forget to insert 
the shoulder screw into the bracket).

E. Repeat steps D on the other side.

3.  Install the decorative lower trim under the door 

using the screws provided with the range.

1.  The range is equipped with two anti-tip "L" brackets 

located on each side of the range with two screws 
(see fi gure 6).

ANTI-TIP "L" BRACKET