Whirlpool WUW55X15DS Benutzeranleitung

Tool Needed: #2 Phillips screwdriver

1. Open the door to a 90° angle and remove the screws for 

the bottom door hinge. 

2. Remove the door by pulling it forward and away from the 

wine cellar.

3. Remove the three screws from the top hinge and remove 

the hinge.

NOTE: There are two hinges for reverse door installation, one for 
a right-hand door swing and one for a left-hand door swing. 
Install the top hinge designed for the desired door swing. 

1. Remove the two screws attaching the bottom hinge to door. 

2. Remove the door by lifting it up, and then pulling it away from 

the wine cellar.

3. Remove the three decorative screws from the upper left 

corner of the front of the wine cellar.

4. Remove the three screws from the right top hinge, and then 

remove the hinge. 

5. Using the three screws removed in the previous step, attach 

the left top hinge to the upper left corner on the front of the 
wine cellar.

NOTE: The left hinge is included in the bag with the Use and 
Care Guide.

6. Insert the three decorative screws removed in Step 3 into the 

three holes in the upper right corner of the front of the wine 
cellar. 

7. Remove the screws for the mechanical switch and door stop; 

remove the mechanical switch and door stop. Attach the 
mechanical switch and door stop to the reverse side of the 
door.

NOTE: The screws for the mechanical door switch are 
located behind the seal. Remove the seal first, and then 
remove the mechanical door switch screws. After reattach 
the mechanical door switch, place the seal in the original 
position.

8. Attach the bottom hinge to the reverse side of the door, and 

then flip the door 180º so that the hinge is now on the bottom 
of the door.

9. Insert the top corner of the door into the top hinge pin and 

reinstall the door on the wine cellar.

10. Press the door and the bottom hinge pin onto the bottom 

hinge. 

11. Check the alignment of the door and the door seals.

12. Tighten the hinge screws (as necessary).