Maytag MGDB755DW Installationsanweisungen

 

■

The gas pipe that comes out through the rear of your dryer 

has a 3/8" male pipe thread.

/

/

3/8" NPT dryer gas pipe

 

■

Use an elbow and a 3/8" flare x 3/8" NPT adapter fitting 

between the flexible gas connector and the dryer gas pipe,  

as needed to avoid kinking.

 

■

Use only pipe-joint compound. Do not use TEFLON

®

 tape.

 

■

This dryer must be connected to the gas supply line with a 

listed flexible gas connector that complies with the standard 

for connectors for gas appliances, ANSI Z21.24 or CSA 6.10.

 

■

When installed above 2,000 ft. (610 m) a 4% reduction of the 

burner Btu rating shown on the model/serial number plate is 

required for each 1,000 ft. (305 m) increase in elevation.

 

■

The dryer must be disconnected from the gas supply piping 

system during pressure testing at pressures greater than  

1/2 psi.

A. 3/8" flexible gas connector

B. 3/8" pipe to flare adapter fitting 

C. 1/8" NPT minimum plugged tapping

D. 1/2" NPT gas supply line

E. Gas shutoff valve.

Using a wrench and tape measure, screw leveling legs into 

leg holes until bottom of foot is approximately 1/2" (13 mm) 

from bottom of dryer.

Now stand the dryer on its feet. Slide the dryer until it is  

close to its final location. Leave enough room to connect  

the exhaust vent.

Gas dryers must be securely fastened to the floor.

Mobile home installations require a Mobile  

Home Installation Hold-down Kit. For  

ordering information please reference  

the “Use and Care Guide.”

To avoid damaging floor, use a large flat piece of cardboard 

from dryer carton; place under entire back edge of dryer. 

Firmly grasp dryer body (not console panel) and gently lay 

dryer down on cardboard.