Maytag MGDB755DW Installationsanweisungen

Connect neutral ground wire (E) and neutral wire (white or 

center wire) (C) of power supply cord or cable under center 

terminal block screw (B). Tighten screw.

Place hooked ends of remaining wires under outer terminal 

block screws (hooks facing right). Tighten screws. 

Connect a separate copper ground wire (G) from the external 

ground conductor screw (A) to an adequate ground. Finally, 

reinsert tab of terminal block cover into slot of dryer rear 

panel. Secure cover with hold-down screw. Now, go to 

Venting Requirements. 

A combination of pipe fittings must be used to connect dryer 

to existing gas line. A recommended connection is shown. 

Your connection may be different, according to supply line 

type, size, and location.

A. 3/8" flexible gas connector

B. 3/8" dryer pipe 

C. 3/8" to 3/8" pipe elbow

D. 3/8" pipe-to-flare adapter fitting

Open shut-off valve in supply line; valve is open when handle 

is parallel to gas pipe. Then, test all connections by brushing 

on an approved noncorrosive leak-detection solution. 

Bubbles will show a leak. Correct any leaks found.

Remove red cap from gas pipe. Using a wrench to tighten, 

connect gas supply to dryer. Use pipe-joint compound  

on threads of all non-flared male fittings. If flexible metal  

tubing is used, be sure there are no kinks.
NOTE: For LP gas connections, you must use pipe-joint 

compound resistant to action of LP gas. Do not use  

TEFLON

®

 tape.

G