Frigidaire FGEF3035R Benutzeranleitung

29

Solutions to common problems

•

Oven control beeps and displays F code 

(fault code) error.

•  The oven control has detected a fault or error condition. Press cancel to 

clear the display & stop beeping. Try the bake or broil feature again. If 

the F code error repeats, remove electric power from appliance, wait 5 

minutes and then repower appliance and set clock for the time of day. 

Try the bake or broil feature again. If the fault recurs, record fault and 

call your authorized service agent.

Poor baking results.

•  Allow oven to preheat to the set temperature before placing food in oven.
•  Make sure the proper oven rack position is used.
•  Center food in the oven and space pans to allow air to circulate.
•  Try adjusting the recipe’s recommended temperature or baking time.
•  If you feel the oven is too hot or cool, see “Adjusting oven temperature” 

in Setting Oven Controls section.

Appliance is not level.

•  Be sure floor is level, strong & stable enough to support the appliance. If 

floor is sagging or sloping, contact a carpenter to correct the problem.

•  Cooktop or oven racks not level. To correct, place oven rack in center of 

oven. Place a bubbel level on the oven rack. Adjust by turning leveling 

legs at base of appliance until the oven rack rests level.

•  Kitchen cabinet alignment may make range appear not level. Be sure 

cabinets are square & have sufficient room for appliance clearance.

Cannot move appliance easily. Appliance 

must be accessible for service.

•  Cabinets not square or are built in too tightly to appliance sides. Contact 

builder or installer to make appliance accessible.

•  Carpet interferes with appliance. Provide sufficient space so appliance 

may be lifted over carpet.

Entire appliance does not operate.

•  Make sure power cord is plugged correctly into outlet.
•  Electrical power outage. Check house lights to be sure. Call your local 

electric company for service.

•  Service wiring is not complete. Contact your dealer, installing agent or 

authorized service agent.

Oven portion of appliance does not 

operate.

•  Be sure the oven controls are set properly for the desired cooking 

feature. See Setting Oven Controls section in this manual or see 

“Entire appliance does not operate” in this checklist.

•  The time of day is not set. The time of day must first be set in order 

to properly operate the oven.  See “Setting the clock” in Setting Oven 

Controls section.

Surface element does not heat cookware. •  Lightweight or warped pans used. Use only flat, evenly balanced, medium 

or heavyweight quality cookware. Flat pans heat better than warped 

pans. Cookware materials and weight of the material affect heating. 

Heavy & medium-weight pans heat evenly. Because lightweight pans heat 

unevenly, foods may burn easily.

Surface element seems too hot or not hot 

enough.

•  Incorrect control setting. Be sure the matching control is set for the surface 

element that you are attempting to use or adjust power level setting.