Maytag MEDB835DW Installationsanweisungen

TOOLS AND PARTS

Gather the required tools and parts before starting installation.

Read and follow the instructions provided with any tools listed

here.

Tools needed for all installations:

Level

#2 Phillips screwdriver

Wire stripper (direct wire

installations)

Parts supplied (all models):

Flat-blade screwdriver

Adjustable wrench that

opens to 1" (25 mm) or

hex-head socket wrench

Tin snips (new vent

installations)

Caulking gun and compound

(for installing new exhaust vent)

Vent clamps

1/4"( 6 mm) nut driver

(recommended)

Tools needed for gas installations:

8" (203 mm) or 10"

(254 mm) pipe wrench

8" (203 mm) or 10"

(254 mm) adjustable wrench

(for gas connections)

Pipe-joint compound

resistant to LP gas

Plastic putty knife

INSTALLATION REQUIREMENTS

Leveling legs (4)

Tape measure

Pliers

Parts supplied (steam models):

“Y” connector

Short inlet hose

5' (1.52 m) inlet hose

Rubber washer

Parts needed (steam models):

Parts package is located in dryer drum. Check that all parts

are included.

If using a power supply cord:

Use a UL listed power supply cord kit marked for use with

clothes dryers. The kit should contain:

■

A UL listed 30-amp power supply cord, rated 120/240 volt

minimum. The cord should be type SRD or SRDT and be

at least 4 ft. (1.22 m) long. The wires that connect to

the dryer must end in ring terminals or spade terminals

with upturned ends.

■

A UL listed strain relief.