Dacor RNR30NFS Installationsanweisungen
16
Installation Instructions
Installing the Range
Peel off the protective layer of plastic that covers the stainless
steel surfaces.
Freestanding Installation
1. Measure from the floor to the countertop and adjust the
leveling legs as required to position the top frame at the
desired height, based on the cabinet and countertop
installation.
2. Carefully slide the range into position in the cutout. As you
slide the unit into place the rear leg should engage the anti-
tip bracket.
3. Using a flashlight look underneath the range and verify that
the anti-tip bracket covers the rear leg. See diagram below.
4. Use a level to make sure that the range does not tilt front to
back or side to side. Re-adjust the legs to level and change
the height if necessary.
Self-Rimming Installation
Installation of the range in the self-rimming configuration is
slightly different from freestanding installation since the range top
overhangs the countertop cutout.
1. Measure from the floor to the countertop.
2. Adjust the leveling legs to position the bottom edge of the
1. Measure from the floor to the countertop.
2. Adjust the leveling legs to position the bottom edge of the
range top trim at countertop height.
3. Carefully slide the range into position in the cutout. As you
slide the unit into place the rear leg should engage the anti-
tip bracket.
4. Using a flashlight look underneath the range and verify that
the anti-tip bracket covers the rear leg. See diagram below.
5. Use a level to make sure that the range does not tilt front to
back or side to side. Re-adjust the legs to level and change
the height if necessary.
Side Panel Removal (Optional -
Model RNR30NI[FS] Only)
If the range will be installed with the partial side panels removed:
1. Remove the three screws just below the oven opening that
1. Remove the three screws just below the oven opening that
hold the kick panel in place.
2. Pull the kick panel straight out to snap it off of the range.
3. Remove the three screws that hold the side panel in place as
3. Remove the three screws that hold the side panel in place as
shown.
4. Push the side panel toward the back of the range to snap it
out of the control panel and remove it.
Anti-tip
bracket
Rear leg